For machine heads with slotted shafts, the string gets cutt off about 5cm behind the respective machine head, inserted at the top, bent over to the side and then wrapped around the shaft. When tuned, there should be about 2 or 3 windings...

For machine heads with slotted shafts, the string gets cutt off about 5cm behind the respective machine head, inserted at the top, bent over to the side and then wrapped around the shaft. When tuned, there should be about 2 or 3 windings...

3-left/3-right Required peghole: 10mm Ratio: 18:1 String post lenght: 31mm Distance from baseplate to string hole: 20mm Weight per piece: 33g

For machine heads with slotted shafts, the string is snipped off about 5cm behind the respective machine head, inserted at the top, bent over at the side and then wrapped around the shaft. When tuned, there should be approximately 2-3...